Master Machine & Tool, LLC
USA
Copyright 2009 Master Machine & Tool, LLC - All Rights Reserved
Master
Machine
& Tool, LLC
M10-2 Cavity
Maximum Product dimensions
Standard Six Cavity:
- Maximum Lip Diameter: 3.50 (89)
- Maximum Standard Height: 7.50 (190.5)
Standard Four Cavity:
- Maximum Lip Diameter:
4.25 (108)
- Maximum Standard Height: 7.50 (190.5)
Standard Wide Four Cavity:
- Maximum Lip Diameter: 5.75 (146)
- Maximum Standard Height:
7.50 (190.5)
Standard Two Cavity:
- Maximum Lip Diameter: 8.00 (203)
- Maximum Standard Height: 5.75 (190.5)
Height Increase is possible
with special design.
- Machine speed: 650 pieces per hour, depending on product size and utilities quality.
- Product size: 8 inches (203mm) Maximum rim diameter.
- Platen opening: Up to 16 inches (405mm) with standard configuration, higher with custom configuration.
- Controls: PLC with data (timer
and counter) preset unit, manual switches for troubleshooting, cycle time readout and totalizing cycle counter.
- Safety: Platen area
guards equipped with shutdown switches, two Emergency stop pushbuttons, two-hand start requirement.
- Lubrication: Manual platen guide
pin, automatic platen cylinder.
- Footprint: 41 inches (1040mm) wide, 20 inches (510mm) deep and 86 inches (2200mm) high.
- Weight: 520
pounds (236 kg).
Utilities requirements:
- Compressed air:
100 PSI (7 bar), with consumption of 12 ft3 (0.35 m3) per minute. Compressed
air valves are "Numatic" brand unless otherwise specified.
- Steam:
15-20 Boiler horsepower (440 lbs., 200 kg)/hr.
- Cooling Water:
9
gallons (36 liters) per minute average, 27 gallons (110 liters) per minute peak.
- Electrical:
120V, 60 Hertz, 3A
240V, 50/60 Hertz,
3A
|
|